Poppits One Step Water Prep

Its unique formula not only set the pH and alkalinity but also keeps them steady for up to 16 weeks minimising the addition of balancing chemicals, saving time, water and money to the spa owners.

• Sets pH and Total Alkalinity in one dose
• pH and Alkalinity remain constant for a period of up to 12-16 weeks
• Dosage rates available in start-up Procedure Card
• Save time
• Save money
• It is classified as non-dangerous good
• Conveniently marked and designed 1L liter jerry can with up to 100mL on chamber
• Dosage are indicated in start-up procedure card

Available Pack Sizes:

• 1L conveniently designed and marked jerry can,
• 2.5L jerry can,
• 5L drums
   

DIRECTIONS FOR USE:

This product is designed to use with POPPITS sanitising systems. It sets and locks the alkalinity and pH levels to recommended range in one simple step.

STEP 1. HEAT & READ

Preheat water in spa to at least 26 degrees then, using the test strip (swirl 3 times and line up with vial) check and record pH and alkalinity. It is important to make the reading within 30 seconds for it to be accurate.

STEP 2. BALANCE WATER with POPPIT ONE STEP WATER PREP

Based on the reading on the strip we can determine how much of the POPPIT ONE STEP WATER PREP to add. Generally town water supply has some level of alkalinity whereas rain water (tank water) has none.

Check levels again next day (please note, the strips read pH slightly lower than actual readings. If reading for pH is at the lower end of the scale than this will be acceptable). Circulate water for 2-3 hours before moving to Step 3.

STEP 3. SANITISE with required amount of POPPIT SANITISERS and circulate for 30 minutes. Your spa is ready for use.

The product may not perform to expectations in Bore Water due to vast differences of mineral content from various regions. Bore Water may require additional adjustment after initial treatment.

Please Contact Us if you need additional information